A 20 ton air/hydraulic jack in the tall configuration, for lift points that sit higher off the ground. Runs off shop air, so there is no hand pumping through a 40,000 lb lift.
The Ken-Tool 21101 is the tall configuration of the company’s 20 ton air jack, built for lift points that sit higher off the ground than a standard-height jack can comfortably reach. Connect it to shop air and the jack does the work, which matters when you are moving 40,000 lb and would otherwise be pumping a handle by hand.
It is one of nine models in Ken-Tool’s 21100 through 21108 jack and stand line, so it pairs directly with the company’s 22 ton and 12 ton stands for a complete raise-and-hold setup. Fully welded construction and chrome-plated components run across the whole line, and every model carries a one-year warranty.
If your lift points sit low or clearance is tight, the same jack is available in a short configuration as item 21102.
$283.47
In stock
Compliance and Restrictions
⚠️WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov
|
Specification |
Value |
|
Item No. |
21101 |
|
Rated capacity |
20 ton (40,000 lb) |
|
Configuration |
Tall |
|
Operation |
Air / hydraulic |
|
Shipping dimensions |
7.5″ x 10.5″ x 11.5″ |
|
Warranty |
One year |
Always support a raised vehicle on stands rated for the load before going underneath it. Never work under a vehicle held by a jack alone. Read all instructions before use.
Companion product: 20 Ton Air Jack – Short (item 21102).
